A FILO loan, short for first-in, last-out loan, is a layer of higher-risk secured debt tucked inside an asset-based lending (ABL) facility that lets a borrower draw more credit against the same collateral than a standard ABL revolver would allow. The FILO tranche advances funds against the slice of receivables or inventory the senior ABL lender considers too risky to finance on its own terms. In return, the FILO lender charges a steep interest premium, often six to eight percentage points above the senior revolver’s spread, and accepts last position when collateral proceeds are distributed.
How a FILO Tranche Fits Inside an ABL Facility
Every asset-based loan is sized by a borrowing base: the lender applies advance rates to eligible receivables and inventory, strips out ineligible assets, subtracts reserves, and the result caps what the borrower can draw. Those advance rates are deliberately conservative. The Office of the Comptroller of the Currency puts the common range at 70% to 85% of eligible receivables and up to 65% of eligible inventory’s book value, or up to 80% of its net orderly liquidation value.1Office of the Comptroller of the Currency. Asset-Based Lending After reserves for dilution and shrinkage, more collateral value sits on the shelf, unfinanced.
That gap is where a FILO loan lives. If a borrower has $100 million in eligible inventory and the senior lender will only advance 60%, the remaining 40% still has real value. A FILO tranche can advance against some or all of that residual, pushing total borrowing capacity higher than the senior facility alone would permit.
Structurally, the FILO tranche usually sits inside the same credit agreement as the senior revolver and shares a first lien on the same collateral. In one publicly filed ABL credit agreement, the FILO was established as a $375 million term loan funded at closing, alongside the revolving facility.2SEC. Exhibit 4.1 – First Amendment to Amended and Restated Credit Agreement The FILO borrowing base is typically calculated separately, using its own advance rate applied to collateral that falls outside the senior tranche’s formula. Some deals fix the FILO borrowing base at closing, so a later decline in collateral value does not trigger a mandatory paydown of the FILO the way it would for the revolver.
That single-agreement, shared-lien structure is what sets FILO apart from most other junior debt. The FILO lender is not a separate secured creditor with its own second lien. It is a participant in the same facility, with contractually inferior payment rights.
The First-In, Last-Out Repayment Waterfall
The name describes how money moves. “First in” means the FILO tranche is funded at closing as a fixed-dollar term loan, before the revolver has necessarily been drawn. “Last out” means the FILO principal gets repaid only after the senior revolver is fully satisfied or reduced to an agreed threshold.
In practice, cash from collecting receivables or liquidating inventory flows first to the senior revolving lender. Only once the revolver balance hits zero, or drops to a contractually specified floor, do collections begin flowing to the FILO tranche. One filed credit agreement states this directly: the borrower must repay revolving loans and protective advances to the administrative agent before any FILO principal payments are made.2SEC. Exhibit 4.1 – First Amendment to Amended and Restated Credit Agreement
The waterfall is memorialized in a formal intercreditor agreement between the FILO lender and the senior ABL agent. The intercreditor document locks in the subordination of FILO payments, allocates enforcement control, and governs how collateral proceeds are distributed. Where it conflicts with the main credit agreement, filed deals confirm that the intercreditor terms control.3SEC. ABL Credit Agreement
This is where the real risk sits. In a liquidation, the senior lender collects against the most liquid assets first. The FILO lender ends up relying on residual value from the riskier, less liquid portion of the collateral pool. If inventory appraisals come in low or receivable collections slow, the FILO lender absorbs those losses first.
Amortization
Unlike the revolver, which fluctuates daily, the FILO tranche is a term loan with a fixed principal balance set at closing. Repaid FILO principal cannot be reborrowed. Ongoing amortization varies by deal. Some agreements call for quarterly amortization at 1.25% of the original principal balance, with the balance due at maturity.2SEC. Exhibit 4.1 – First Amendment to Amended and Restated Credit Agreement Others use a fixed monthly schedule, such as a 24-month amortization beginning the first full month after funding.4SEC. Exhibit 10.2 – Credit Agreement Some FILO loans require no amortization at all, with the full balance due as a bullet payment at maturity.
What a FILO Loan Costs
FILO lenders charge a substantial premium over the senior revolver to compensate for their subordinated position. The gap is not subtle. In one publicly filed retail credit agreement, the senior ABL revolver carried a spread of roughly 1.60% to 2.10% over Term SOFR, depending on the borrower’s excess availability. The FILO tranche in the same deal carried a spread of 8.75% to 9.75% over Term SOFR.5SEC. Third Amendment to Amended and Restated Credit Agreement That is a premium of roughly 665 to 815 basis points above the revolver rate. Spreads vary across deals, but the size of the gap reflects the FILO lender’s genuine subordination risk.
Prepayment penalties typically protect the FILO lender’s return if the borrower refinances early. One filed agreement imposed a 1.00% prepayment premium on outstanding FILO principal if prepaid within the first two years after closing.3SEC. ABL Credit Agreement Other deals use a declining schedule, starting at 2.00% in year one, 1.00% in year two, and zero after the second anniversary. Call protection periods are commonly two years.
FILO Compared to Second Lien and Mezzanine Debt
A FILO tranche, a second lien term loan, and mezzanine debt all occupy the junior debt space, but they differ in ways that affect cost, flexibility, and control during distress.
- Lien position. A FILO shares a first lien with the senior revolver but accepts subordinated payment rights through the intercreditor agreement. A second lien loan holds a separate junior lien on the same collateral. The practical consequence is that the FILO lender’s claim is resolved inside the senior facility’s framework rather than as a separate secured creditor class.
- Cost. FILO pricing typically falls between a senior revolver and true mezzanine debt. Mezzanine lenders, often unsecured or deeply subordinated, charge the highest rates. FILO lenders charge less because they still hold a first lien, even if their payment priority is junior.
- Borrowing base linkage. FILO tranches are tied to the ABL borrowing base, with advances keyed to specific collateral values. Mezzanine debt is almost always sized to cash flow multiples with no direct collateral formula. Second lien loans may or may not use a borrowing base.
- Intercreditor complexity. FILO intercreditor agreements tend to be tighter than second lien agreements because both tranches share the same lien. The senior lender controls most enforcement decisions, and the FILO lender’s remedies are heavily restricted by standstill provisions.
For a borrower, the trade-off is this: a FILO is usually cheaper than mezzanine and simpler to document than a separate second lien facility, but it gives the FILO lender less independent control. Companies with strong collateral bases and limited cash flow often find FILO the most efficient way to access incremental liquidity without layering on a completely separate debt instrument.
What Happens When a Borrower Defaults
The intercreditor agreement determines who holds the cards. In most FILO structures, the senior ABL lender controls enforcement. The FILO lender is subject to a standstill period during which it cannot independently accelerate the loan or seize collateral. Standstill periods are negotiated deal by deal; one filed intercreditor agreement set the standstill at 5 business days for monetary defaults and 10 business days for non-monetary defaults after notice.6SEC. Intercreditor, Standstill and Subordination Agreement
During the standstill, the FILO lender typically has a right to cure the borrower’s default by making payments on its behalf. That cure right has limits. In one agreement, if the FILO lender had been curing defaults continuously for more than six months, the right expired.6SEC. Intercreditor, Standstill and Subordination Agreement The senior lender can also override the standstill if waiting would materially impair the collateral’s value.
If a default escalates to a payment default or bankruptcy, the intercreditor agreement typically gives the senior agent (and sometimes the FILO agent jointly) the right to direct a sale of the borrower’s assets.7SEC. Exhibit 10.3 – Jo-Ann Stores LLC Senior Secured FILO Facility Commitment Letter Proceeds flow through the same waterfall: senior revolver first, FILO second. The FILO lender recovers only what remains after the senior lender is made whole. For borrowers, that means defaulting on a facility with a FILO tranche often means losing control of the process quickly.
Who Typically Uses FILO Loans
FILO structures have become increasingly common in special situations finance, particularly for companies with large collateral bases that face operational or financial stress. Retailers are the most visible users: they carry substantial inventory and receivable balances that support ABL facilities, but cash flow volatility often caps how much a traditional lender will advance. The publicly filed FILO agreements referenced throughout this article involve large national retailers, and that pattern is representative of the broader market.
Beyond retail, FILO tranches appear in distribution, healthcare, and other asset-heavy industries where the gap between collateral value and senior advance rates is wide enough to justify the cost. Companies use them to fund acquisitions where the purchase price exceeds what the senior ABL alone can support, to bridge a seasonal liquidity gap, or to recapitalize after a period of distress. The structure is also useful in Chapter 11 exit financing, where a company emerging from bankruptcy needs maximum liquidity from its asset base but has limited access to unsecured debt markets.
Tax Treatment of High-Interest FILO Debt
The steep interest rates on a FILO tranche raise a practical tax question: can the borrower actually deduct all of that interest? Under Section 163(j) of the Internal Revenue Code, a business can generally deduct business interest expense only up to 30% of its adjusted taxable income in a given year, plus any business interest income.8Internal Revenue Service. Questions and Answers About the Limitation on the Deduction for Business Interest Expense Interest above the cap is not lost; it carries forward. But for a company paying SOFR plus 9% or more on a sizable FILO tranche on top of its revolver interest, hitting the 30% ceiling is a real possibility.
For tax years beginning after December 31, 2025, the computation of adjusted taxable income under Section 163(j) also changes. U.S. shareholders of controlled foreign corporations can no longer include certain CFC income in the adjusted taxable income calculation, which may further reduce deductible interest for multinational borrowers.8Internal Revenue Service. Questions and Answers About the Limitation on the Deduction for Business Interest Expense The headline interest rate on a FILO overstates the effective cost if the interest is fully deductible and understates the cash burden if part of the deduction gets deferred, so modeling the after-tax cost matters before signing on.