Inventory is valued at cost, not at retail. The price you paid for the goods, plus freight, duties, and anything else it took to get them ready for sale, is the number that lands on your balance sheet and your tax return. Retail prices enter the picture only as an estimation shortcut: some high-volume retailers work backward from selling prices to approximate what the goods originally cost, but the goal is still a cost figure. So when the question is whether inventory is valued at cost or retail, the answer is cost, with one method that uses retail prices as a stepping stone to get there.
What “Cost” Actually Means
For tax purposes, the IRS recognizes two acceptable ways to value inventory: at cost, or at the lower of cost or market. 1Internal Revenue Service. Lower of Cost or Market Either way, the starting point is the actual cost of acquiring the goods.
For merchandise you buy for resale, cost means the invoice price minus trade discounts, plus shipping and any other charges you incurred getting the goods to your location. For goods you manufacture, cost also includes raw materials, direct labor, and a share of factory overhead such as utilities and equipment depreciation.
Certain producers and resellers have to go further. Under Section 263A, they must capitalize additional indirect expenses like warehousing, purchasing department costs, and administrative overhead that are allocable to inventory. 2Office of the Law Revision Counsel. 26 USC 263A – Capitalization and Inclusion in Inventory Costs of Certain Expenses Those costs stay in inventory until the goods are sold, at which point they flow into cost of goods sold. Small businesses that meet the gross receipts test are exempt.
The reliance on historical cost exists because it is objective and verifiable. Unlike a projected selling price, the amount you paid is documented by invoices, contracts, and payment records. That verifiability matters to auditors, lenders, and the IRS alike.
When Inventory Drops Below Cost
Cost is the ceiling, not always the number on the books. Goods get damaged, styles go out of fashion, or replacement prices drop below what you paid. Both GAAP and the IRS require you to write inventory down in those situations, but they measure the shortfall differently.
The GAAP Rule
For inventory measured using FIFO or weighted average cost, GAAP requires you to compare cost against net realizable value: the estimated selling price minus any costs to complete and sell the goods. If a product would sell for $100 but needs $20 in finishing and selling costs, its net realizable value is $80. When that figure drops below the recorded cost, you write the inventory down and recognize the difference as a loss immediately. 3Financial Accounting Standards Board. ASU 2015-11, Inventory (Topic 330)
Once you write inventory down under GAAP, the reduced amount becomes the new cost basis. You do not reverse the write-down if prices later recover. This one-way ratchet reflects the conservative principle that assets should not be overstated, even temporarily.
One wrinkle catches people out. The net realizable value rule does not apply to LIFO or retail method inventory. Those categories still follow the older lower of cost or market framework, where “market” generally means replacement cost rather than net realizable value. 3Financial Accounting Standards Board. ASU 2015-11, Inventory (Topic 330)
The IRS Rule
For tax purposes, “market” means the current bid price: the amount you would pay on the open market to replace or reproduce the goods on the inventory date. 1Internal Revenue Service. Lower of Cost or Market If replacement cost has fallen below what you paid, you value the inventory at that lower figure. The comparison can be made item by item or by inventory category, though the item-by-item approach catches the most impairment.
Where Retail Prices Come In: The Retail Inventory Method
The one place retail prices show up in inventory valuation is the retail inventory method, and even there the point is to estimate cost. Department stores, grocery chains, and similar operations use it because counting thousands of low-price items at their original cost after every reporting period would be prohibitively expensive.
The method works through a cost-to-retail ratio. You divide the total cost of goods available for sale by their total retail value. If your goods cost $60,000 and their combined retail price is $100,000, the ratio is 60%. You then count your ending inventory at retail prices and multiply by that ratio. Ending inventory marked at $30,000 retail multiplied by 60% gives an estimated cost of $18,000. 1Internal Revenue Service. Lower of Cost or Market
The method also doubles as a theft-detection tool. If the estimated inventory cost at the end of a period is significantly higher than what a physical count reveals, the gap points to shrinkage, damage, or employee theft. The IRS permits the retail method as long as it is applied consistently and reasonably approximates actual cost.
Which Cost Attaches to Which Unit
Once you accept that inventory is recorded at cost, a second question follows. When you buy the same product at different prices over time, which cost attaches to the units you sell and which cost stays in your remaining inventory? Under U.S. GAAP, the acceptable cost flow assumptions are first-in first-out (FIFO), last-in first-out (LIFO), weighted average cost, and specific identification. 4Internal Revenue Service. Publication 538, Accounting Periods and Methods Whichever method you choose, you must apply it consistently from year to year.
FIFO assumes the oldest units in stock are the first ones sold, which lines up with how most businesses actually move perishable or time-sensitive products. Remaining inventory is valued using the most recent purchase costs, so the balance sheet number stays close to current replacement prices. During periods of rising prices, FIFO produces the highest reported profit because the cheaper, older costs flow into cost of goods sold.
LIFO flips the assumption. The most recently purchased units are treated as the first ones sold, so cost of goods sold reflects current prices while ending inventory sits at older, sometimes much lower costs. Businesses that elect LIFO for tax purposes must also use it in reports to shareholders, partners, and creditors under the LIFO conformity rule. 5Office of the Law Revision Counsel. 26 USC 472 – Last-in, First-out Inventories LIFO is prohibited under International Financial Reporting Standards, so companies reporting under IFRS cannot use it. 6IFRS Foundation. IAS 2 Inventories
Weighted average cost blends all purchase prices into a single per-unit cost. Divide the total cost of goods available for sale by the total number of units, and that figure applies to both the units you sell and the units left on hand. The approach smooths out price swings and works especially well for fungible goods like grain, fuel, or chemicals.
Specific identification tracks the actual cost paid for each individual item. The IRS requires it when items are not interchangeable. 4Internal Revenue Service. Publication 538, Accounting Periods and Methods A car dealership, a jeweler, or an art gallery uses specific identification because each piece has a unique cost and lumping them into an average would misrepresent both profit and inventory value.
When You Can Skip Inventory Accounting Altogether
Not every business that sells physical goods has to run through this whole framework. Section 471(c) exempts businesses that meet the gross receipts test under Section 448(c), which for tax years beginning in 2026 means average annual gross receipts of $32 million or less over the prior three years. 7Internal Revenue Service. Revenue Procedure 2025-32 Tax shelters are excluded regardless of size.
Qualifying businesses can either treat inventory as non-incidental materials and supplies, deducting the cost in the year the goods are sold or paid for (whichever comes later), or follow whatever method they use on their audited financial statements or internal books. 8Office of the Law Revision Counsel. 26 USC 471 – General Rule for Inventories The same exemption also releases them from the UNICAP capitalization rules under Section 263A. 2Office of the Law Revision Counsel. 26 USC 263A – Capitalization and Inclusion in Inventory Costs of Certain Expenses The gross receipts threshold is adjusted annually for inflation, so check the current Revenue Procedure each year to confirm eligibility.