Municipal bonds are rated by independent credit rating agencies that review a government’s finances, economy, debt load, and management, then assign a letter grade that predicts how likely bondholders are to be paid on time. The three agencies that dominate the municipal market are Moody’s Investors Service, S&P Global Ratings, and Fitch Ratings. Their grades run from a top mark of Aaa or AAA down through speculative tiers, and each notch on the scale directly affects what the issuer pays to borrow.
Who Assigns the Ratings
Moody’s, S&P, and Fitch are all registered with the Securities and Exchange Commission as Nationally Recognized Statistical Rating Organizations, a designation created by the Credit Rating Agency Reform Act of 2006 that subjects them to federal oversight and reporting requirements.1U.S. Securities and Exchange Commission. Current NRSROs The SEC’s registered list also includes firms like Kroll Bond Rating Agency and DBRS, which rate some municipal issues, though the three larger agencies see the most municipal work.
Each agency runs its own methodology, scorecard, and analytical staff, so two agencies can assign slightly different grades to the same bond. The gap is usually small for high-quality issuers and wider near the edges of investment grade. Many large issuers pay for ratings from two agencies to give investors a second opinion; smaller issuers sometimes use only one.
Ratings are paid for by the issuer, not the investor. Fees from issuers account for roughly 90 to 95 percent of rating agency revenue, a structure known as the issuer-pay model. Congress addressed the conflict-of-interest concern through the 2006 reform act and later through Dodd-Frank Act provisions requiring the SEC to adopt rules governing rating agency sales practices, internal controls, and analyst independence.2U.S. Securities and Exchange Commission. Credit Rating Agencies – Dodd-Frank Act Rulemaking
How the Rating Scale Reads
Every scale divides into two broad camps: investment grade and speculative grade (often called “junk”). The dividing line sits at BBB- for S&P and Fitch, and at Baa3 for Moody’s. Anything at or above that threshold is investment grade; anything below signals meaningfully higher default risk.3Municipal Securities Rulemaking Board. Credit Rating Basics for Municipal Bonds on EMMA
S&P and Fitch use an identical letter system with plus and minus modifiers to show where a bond sits within a category. AA+ is stronger than AA, and AA is stronger than AA-. Moody’s uses a parallel structure but expresses the modifiers as numbers: Aa1 is highest within the Aa range, Aa2 middle, and Aa3 lowest. Those numeric modifiers run from the Aa category through Caa.4Moody’s Investors Service. Moody’s US Municipal Bond Rating Scale The top rating (Aaa or AAA) stands alone with no modifier.
The investment-grade tiers line up like this:
- Highest quality: Moody’s Aaa / S&P AAA / Fitch AAA
- High quality: Moody’s Aa1–Aa3 / S&P AA+ to AA- / Fitch AA+ to AA-
- Upper-medium grade: Moody’s A1–A3 / S&P A+ to A- / Fitch A+ to A-
- Lower-medium grade: Moody’s Baa1–Baa3 / S&P BBB+ to BBB- / Fitch BBB+ to BBB-
Anything below those tiers enters speculative territory, where borrowing costs climb and many institutional investors are prohibited by their own mandates from holding the bonds.
Outlooks and Watchlist Designations
A rating by itself is a snapshot. Agencies supplement it with forward-looking signals that warn investors something may change. S&P uses two distinct tools. A “Rating Outlook” reflects the agency’s view over the intermediate term, generally up to two years for investment-grade bonds and up to one year for speculative-grade bonds, and is assigned when analysts see at least a one-in-three chance of a rating change over that horizon. An outlook can be positive, negative, stable, or developing.5S&P Global Ratings. General Criteria: Use of CreditWatch and Outlooks
“CreditWatch” is a more urgent flag. S&P places a bond on CreditWatch when a specific event creates at least a one-in-two chance of a rating change within 90 days. A sudden revenue collapse, a legal ruling, or a governance crisis are typical triggers. While a bond sits on CreditWatch, the regular outlook is suspended until the review concludes.5S&P Global Ratings. General Criteria: Use of CreditWatch and Outlooks Moody’s and Fitch operate similar systems under different names, but the logic is the same: outlooks signal gradual drift, and watch placements signal a near-term event that demands immediate analytical attention.
What Analysts Evaluate on General Obligation Bonds
General obligation bonds are backed by the issuer’s full taxing authority, so the rating reflects the overall financial strength of the government rather than any single revenue stream. Moody’s publishes a detailed scorecard for cities and counties that breaks the analysis into four weighted categories, and the framework shows exactly what drives the final grade.
- Economy (30% weight): median household income relative to the national figure, full property value per capita, and local GDP growth compared with the national average. A diversified employment base with no single employer or industry dominating the tax rolls strengthens this score.
- Financial performance (30% weight): the available fund balance as a share of revenue (essentially the rainy-day reserve) and unrestricted cash relative to revenue. Analysts look for liquidity adequate to cover operations without short-term borrowing, often benchmarking against at least 60 to 90 days of cash on hand.
- Leverage (30% weight): total long-term liabilities divided by revenue, including debt, adjusted net pension liability, and net retiree healthcare obligations. A separate fixed-costs ratio captures annual debt service and pension contributions as a share of revenue. Large unfunded pension liabilities show up here and can drag down an otherwise healthy profile.
- Institutional framework (10% weight): a qualitative factor capturing the legal and governance environment the municipality operates within, including state-level fiscal rules, home-rule authority, and the quality of financial management practices like multi-year budgeting and formal reserve policies.
S&P and Fitch use broadly similar frameworks with their own terminology and weightings, but the core questions are the same: how strong is the local economy, how well does the government manage its money, and how sustainable are its long-term obligations?
Pensions get special attention. Rating agencies evaluate pension obligations through their own analytical models, not simply by looking at the figures reported under Government Accounting Standards Board rules.6GASB. Summary of Statement No. 68 Moody’s, for example, applies its own discount rate assumptions to recalculate pension liabilities independently of what the municipality reports on its financial statements. A city with a massive unfunded pension gap that fails to make adequate annual contributions will see that reflected in the leverage score regardless of how its audited financials present the numbers.
How Revenue Bond Ratings Differ
Revenue bonds are a different animal. Instead of being backed by the government’s taxing power, they depend entirely on income generated by a specific project or enterprise: a water utility, a toll road, an airport, a hospital. The rating reflects the financial viability of that particular operation, not the broader government behind it.
The central metric is the debt service coverage ratio, which divides annual net revenue from the project by the annual debt payments owed. A coverage ratio of 1.25x means the project earns 25 percent more than it needs to pay bondholders. That 1.25x figure is a common floor written into bond indentures as a legal covenant, though stronger credits often clear 1.5x or higher. Falling below the covenant triggers remedies spelled out in the indenture, which might include hiring a consultant, raising rates, or restricting new spending.
The bond indenture also typically requires the issuer to maintain a debt service reserve fund, often sized at one year’s worth of payments, which cushions bondholders if revenue dips temporarily. Analysts evaluate those legal protections alongside the operating fundamentals of the enterprise, because the strongest revenue stream in the world means little if the legal structure lets other parties drain it before bondholders get paid.
The Rating Process From Start to Finish
A municipality initiating a bond sale typically engages one or two rating agencies well before the bonds come to market. The process starts with submitting several years of audited financial statements, current and projected budgets, capital improvement plans, and data on the local economy. For revenue bonds, the package includes operating statements for the specific enterprise and a copy of the bond indenture.
After reviewing the documents, agency analysts schedule meetings with local officials to probe areas the numbers alone cannot answer. How does the city plan to address a growing pension shortfall? What happens to the water utility’s revenue if a major industrial customer leaves? How does the county plan to fund deferred infrastructure maintenance? These conversations often reveal more about management quality than any financial ratio.
Once the analyst completes an internal report, a rating committee votes on the final grade. The committee structure exists specifically to prevent any single analyst’s judgment from determining the outcome. After the rating is published, agencies maintain ongoing surveillance, reviewing financial updates at least annually and adjusting the rating or outlook when conditions warrant. An unexpected factory closure, a natural disaster, or a state-level policy change can all trigger a mid-cycle review.
What the Grades Have Meant Historically
Municipal bonds have a low historical default rate, and that context matters when interpreting the scale. From 1970 through 2022, investment-grade municipal bonds carried a five-year cumulative default rate of just 0.04 percent, compared with 0.87 percent for investment-grade corporate bonds. Even at the Baa level, the lowest investment-grade tier, municipal five-year defaults averaged 0.44 percent, roughly a third of the comparable corporate rate of 1.47 percent.
The numbers get worse quickly once you leave investment grade. Speculative-grade municipal bonds defaulted at a five-year rate of 4.63 percent, and B-rated munis hit 11.74 percent. Ratings genuinely sort risk in the municipal market, but the baseline risk for investment-grade munis is very low.
What a Downgrade Costs
A downgrade hits an issuer in two places at once. On future borrowing, each notch of downgrade translates into a higher interest rate. Research has estimated roughly six basis points of additional yield per notch in the investment-grade range. On a $100 million bond issue over 20 years, six basis points adds up to real money.
For bonds already trading in the secondary market, a downgrade tends to push prices down and widen the gap between what buyers will pay and what sellers want. Bonds that have recently been downgraded face greater liquidity risk, meaning investors trying to sell may need to accept a steeper discount.7MSRB. Municipal Bond Investment Risks The damage compounds if the downgrade crosses the investment-grade threshold, because many institutional investors and mutual funds are required to sell bonds that fall below BBB- or Baa3, flooding the market with supply at exactly the wrong time.
Not Every Municipal Bond Is Rated
Approximately 34 percent of local municipal bond offerings between 1998 and 2017 came to market without a rating, though these tended to be smaller issues that represented about 14 percent of total dollar volume.8FDIC. Do Municipalities Pay More to Issue Unrated Bonds? The absence of a rating does not automatically mean the bond is risky, but investors lose the benefit of professional credit analysis and ongoing surveillance and must perform their own due diligence on the issuer’s financial statements, economic base, and debt burden.
The market prices this information gap into unrated bonds through higher yields. Some issuers may avoid a rating because they expect a poor result, which creates an adverse-selection problem: the unrated pool likely contains a disproportionate share of weaker credits. Historical data supports that concern, with unrated bonds defaulting at roughly double the rate of the rated universe.8FDIC. Do Municipalities Pay More to Issue Unrated Bonds?
Looking Up a Bond’s Rating
The Municipal Securities Rulemaking Board runs a free public site called EMMA (Electronic Municipal Market Access) that displays credit ratings, official financial disclosures, and trade data for virtually every municipal bond in the market.9Investor.gov. Using EMMA – Researching Municipal Securities and 529 EMMA pulls ratings from Moody’s, S&P, Fitch, and Kroll, so you can see whether different agencies agree on the grade.3Municipal Securities Rulemaking Board. Credit Rating Basics for Municipal Bonds on EMMA If you are buying individual municipal bonds rather than a fund, checking EMMA before you invest is the bare minimum level of diligence. The rating alone will not tell you everything, but it is the starting point for understanding what you own.