Conforming Loan Limits: 2026 Amounts and High-Cost Areas

The 2026 conforming loan limits set the maximum mortgage amount that Fannie Mae and Freddie Mac will buy. For a single-unit home in most of the country, the baseline is $832,750. In designated high-cost areas, and across Alaska, Hawaii, Guam, and the U.S. Virgin Islands, the cap rises to $1,249,125 for a one-unit property.1Federal Housing Finance Agency. FHFA Announces Conforming Loan Limit Values for 2026 Multi-unit properties carry higher caps at both tiers.

The baseline climbed $26,250 from 2025. It applies across the contiguous 48 states, the District of Columbia, and Puerto Rico. What counts is the loan amount at origination; a conforming loan that later appreciates doesn’t lose its status.

2026 Baseline Limits by Property Size

Fannie Mae and Freddie Mac set higher caps for properties with more units because they cost more and generate rental income that supports the mortgage. The 2026 baseline limits for the contiguous states, DC, and Puerto Rico are:2Fannie Mae. Loan Limits

  • One unit: $832,750
  • Two units: $1,066,250
  • Three units: $1,288,800
  • Four units: $1,601,750

Properties with five or more units sit outside the conforming framework entirely and are financed as commercial real estate.

High-Cost Area Limits

Counties where housing is substantially more expensive than the national average get a higher ceiling. Under the Housing and Economic Recovery Act, the limit rises in any area where 115% of the local median home value exceeds the baseline, up to a maximum of 150% of the baseline.3Federal Housing Finance Agency. FHFA Conforming Loan Limit Values For 2026, that produces these ceilings:2Fannie Mae. Loan Limits

  • One unit: $1,249,125
  • Two units: $1,599,375
  • Three units: $1,933,200
  • Four units: $2,402,625

Not every expensive county hits the full ceiling. Many fall somewhere between the baseline and the maximum, depending on local sales data. The FHFA analyzes county-level home prices and assigns each county its own figure. Loans that fall between the baseline and the high-cost ceiling are sometimes called “conforming high-balance” or “super conforming” mortgages. They follow the same underwriting rules as standard conforming loans, though lenders may charge a slightly higher interest rate on the larger balance.

Alaska, Hawaii, Guam, and the U.S. Virgin Islands

Federal law gives these four areas a higher statutory floor because of consistently elevated construction and land costs. For 2026, the baseline for a one-unit property in Alaska, Hawaii, Guam, and the U.S. Virgin Islands is $1,249,125, equal to the high-cost ceiling elsewhere.1Federal Housing Finance Agency. FHFA Announces Conforming Loan Limit Values for 2026 Multi-unit baselines in these areas match the high-cost multi-unit figures listed above.2Fannie Mae. Loan Limits

Hawaii also has specific counties designated as high-cost areas above that floor. For a two-unit property in those counties, the 2026 ceiling reaches $1,633,600. Alaska, Guam, and the U.S. Virgin Islands do not currently have counties designated as high-cost above their statutory floor.

Why the Limit Matters

A mortgage qualifies as conforming when it meets Fannie Mae and Freddie Mac’s acquisition guidelines, with loan size being the headline requirement. The statutory definition ties the term directly to the dollar limitations in each enterprise’s charter.4Office of the Law Revision Counsel. 12 USC 4502 – Definitions Any loan above the cap is non-conforming and falls into the jumbo market, where lenders typically charge higher interest rates and require larger down payments because they cannot sell the risk to Fannie Mae or Freddie Mac.

If your target purchase price puts your loan just over the limit, two moves can bring you back under: increase the down payment, or check whether your county qualifies as high-cost. The gap in borrowing costs between a conforming loan and a jumbo loan is usually enough to make the arithmetic worth running.

How the Limits Change Each Year

The Housing and Economic Recovery Act of 2008 created the formula FHFA uses for annual adjustments. Each year, the agency tracks national home price changes through its Expanded Data House Price Index, and the baseline limit moves by a proportional amount the following year.5Federal Housing Finance Agency. The Dynamics of FHFA Conforming Loan Limits and House Prices

FHFA typically announces the next year’s figures in late November, with lenders updating their systems before January. If you’re shopping near the current cap late in the year in a rising market, waiting for the new limit to take effect can keep you in conforming territory.

Finding Your County’s Exact Limit

Because limits vary county by county in high-cost areas, confirm your specific figure before you make an offer. The FHFA publishes the complete county-by-county table in spreadsheet, PDF, and interactive map formats on its conforming loan limit page.3Federal Housing Finance Agency. FHFA Conforming Loan Limit Values Specific questions can go to the agency at LoanLimitQuestions@fhfa.gov. Checking the number early prevents the mid-application surprise of learning your loan amount has pushed you into jumbo territory, where the qualification bar is meaningfully higher.