Bank Ratios: Capital, Liquidity, Profitability, Asset Quality

Bank financial ratios turn a bank’s balance sheet and income statement into a dozen or so numbers that tell you whether the institution can absorb losses, pay its short-term bills, earn a reasonable return, and manage its loan book. Four categories do most of the work: capital adequacy, liquidity and funding, profitability, and asset quality. Each has published regulatory thresholds or widely accepted benchmarks, so you can read a bank’s quarterly report and form your own view without taking anyone’s word for it. The Common Equity Tier 1 (CET1) ratio is the one to start with. It must stay at or above 4.5% of risk-weighted assets under federal rules, and buffers push the practical floor to 7% or higher for large banks.

Capital Ratios: Loss-Absorbing Cushion

Capital adequacy answers the most basic question about a bank: if a chunk of its loans go bad tomorrow, is there enough of a cushion to stay solvent? Regulators measure that cushion by comparing capital against risk-weighted assets (RWA). RWA adjusts each asset’s dollar value for credit risk. A U.S. Treasury bond gets a 0% weight because default risk is essentially zero; a standard commercial loan carries a 100% weight.1National Credit Union Administration. Risk Weights at a Glance The output is a single number that reflects not just how many assets the bank holds but how risky those assets are.

Capital itself comes in tiers. Tier 1 is permanently available to absorb losses while the bank keeps operating, and includes common stock and retained earnings. Tier 2 covers supplementary instruments like subordinated debt that absorb losses only if the bank actually fails. Regulators care most about the capital that keeps a bank alive, which is why CET1 gets top billing.

CET1 Ratio

The Common Equity Tier 1 ratio divides a bank’s highest-quality capital (common stock and retained earnings) by total risk-weighted assets. The regulatory floor is 4.5%.2eCFR. 12 CFR 3.10 – Minimum Capital Requirements On top of that sits the capital conservation buffer of 2.5%, composed entirely of CET1 capital.3eCFR. 12 CFR 3.11 – Capital Conservation Buffer and Countercyclical Capital Buffer Amount A bank whose CET1 dips below the combined 7% threshold faces automatic restrictions on dividends, share buybacks, and discretionary bonus payments.4Bank for International Settlements. RBC30 – Buffers Above the Regulatory Minimum Most well-run banks keep CET1 comfortably above 10%.

Total Capital Ratio

Total capital adds Tier 1 and Tier 2 together and divides the sum by risk-weighted assets. The regulatory minimum is 8%.2eCFR. 12 CFR 3.10 – Minimum Capital Requirements Because this metric includes subordinated debt, it gives a broader view of all capital available to cover losses. A bank with a strong CET1 but a total capital ratio barely above 8% is leaning heavily on lower-quality capital.

Tier 1 Leverage Ratio

Risk-weighted ratios can be gamed. If a bank’s internal models understate the riskiness of certain assets, its RWA-based ratios look better than reality warrants. The Tier 1 leverage ratio works as a backstop by dividing Tier 1 capital by total average assets with no risk weighting at all. The U.S. minimum is 4%.2eCFR. 12 CFR 3.10 – Minimum Capital Requirements Internationally, Basel III sets a lower floor of 3%.5Bank for International Settlements. Basel III Leverage Ratio Framework and Disclosure Requirements The eight U.S. global systemically important banks face a supplementary leverage ratio requirement of at least 5%.6Office of Financial Research. Banks’ Supplementary Leverage Ratio

What “Well Capitalized” Actually Means

Clearing the minimums is not the same as being healthy. Under prompt corrective action rules, a bank qualifies as “well capitalized” only if it clears a higher set of thresholds: a CET1 ratio of 6.5%, a Tier 1 risk-based ratio of 8%, a total capital ratio of 10%, and a leverage ratio of 5%.7eCFR. 12 CFR Part 6 – Prompt Corrective Action Falling below that classification triggers escalating restrictions, including limits on accepting brokered deposits and on paying above-market interest rates on savings accounts.8FDIC. Brokered Deposits “Well capitalized” is the bar most investors and depositors should treat as the real floor.

Liquidity and Funding Ratios: Can It Pay Its Bills?

A bank can be perfectly solvent on paper and still collapse if it runs out of cash. Liquidity ratios measure short-term cash-paying ability. Funding ratios look at whether long-term funding sources are reliable enough to support the asset base. Capital protects against permanent losses; liquidity protects against the temporary inability to convert assets into cash fast enough.

Liquidity Coverage Ratio

The Liquidity Coverage Ratio (LCR) asks a direct question: if depositors and creditors started pulling money for 30 consecutive days under severe stress, could the bank cover every outflow with high-quality liquid assets like cash and government bonds? The LCR divides that stock of high-quality liquid assets by projected net cash outflows over the 30-day window.9Bank for International Settlements. Basel III: The Liquidity Coverage Ratio and Liquidity Risk Monitoring Tools U.S. rules require covered institutions to maintain an LCR of at least 1.0 (100%) on every business day.10eCFR. 12 CFR 50.10 – Liquidity Coverage Ratio Most large banks run well above that floor.

Net Stable Funding Ratio

Where the LCR covers 30 days, the Net Stable Funding Ratio (NSFR) looks at a one-year window. It divides available stable funding (capital, long-term debt, and sticky retail deposits) by the stable funding the bank’s assets require, with less liquid assets demanding more stable funding behind them. The minimum is 100%.11Office of the Comptroller of the Currency. OCC Bulletin 2021-9 – Net Stable Funding Ratio: Final Rule An NSFR well below 100% signals that the bank is relying too heavily on short-term wholesale borrowing to fund long-dated loans. That is the funding mismatch that sinks banks during credit crunches.

Loan-to-Deposit Ratio

The loan-to-deposit ratio divides total loans outstanding by total customer deposits. A ratio between roughly 80% and 90% suggests the bank is funding most of its lending from its own deposit base, the cheapest and most stable source. Above 100% means the bank is borrowing from wholesale markets or other banks to lend. That is not automatically dangerous, but it adds funding risk if those sources dry up. A very low ratio can mean the bank is sitting on deposits without putting them to productive use, which drags on profitability.

Deposit Quality

Not all deposits are equal. Core deposits (checking accounts, savings accounts, small CDs) are stable because individual customers rarely move money over small rate changes. Brokered deposits, placed by third-party intermediaries chasing the best rate, are far more volatile. Banks that fall below “well capitalized” are restricted from accepting brokered deposits entirely, though adequately capitalized banks can apply to the FDIC for a waiver.8FDIC. Brokered Deposits A high proportion of brokered deposits often means the institution is paying above-market rates to attract funds it cannot generate organically.

Profitability and Efficiency Ratios

Capital and liquidity tell you whether a bank can survive adversity. Profitability tells you whether the business model works. Strong earnings let a bank build capital internally, invest in technology, and absorb occasional bad quarters without emergency fundraising.

Return on Assets

Return on Assets (ROA) divides net income by average total assets. A well-performing bank typically produces an ROA between 1% and 1.5%. The number sounds small until you remember how leveraged banks are: a $100 billion bank with a 1.2% ROA generates $1.2 billion in profit. An ROA below 0.5% for several consecutive quarters is a red flag, pointing to poor lending decisions, expensive funding, or heavy operating costs.

Return on Equity

Return on Equity (ROE) divides net income by average shareholder equity. Between 10% and 15% is generally considered healthy for a commercial bank. The catch is leverage. A bank with razor-thin capital will show a high ROE because the denominator is small, and that high return comes with elevated risk. Always read ROE next to CET1. A 14% ROE at a bank with CET1 above 12% reflects genuine efficiency. A 14% ROE at a bank with CET1 near 7% reflects more risk-taking.

Net Interest Margin

Net Interest Margin (NIM) captures the core economics of banking: the spread between what a bank earns on loans and investments and what it pays depositors and other creditors. It divides net interest income by average earning assets. Commercial banks typically report NIMs between 3% and 4.5%, fluctuating with interest rate cycles. A rising-rate environment usually helps NIM because loan rates reprice faster than deposit costs; a flat or inverted yield curve compresses it. A steadily declining NIM often reflects competitive pressure on loan pricing or a shift toward lower-yielding, safer assets.

Efficiency Ratio

The efficiency ratio divides non-interest expense (salaries, rent, technology) by net revenue (net interest income plus fee income). Lower is better. Below 60% means the bank is spending less than 60 cents to produce every dollar of revenue; top performers get closer to 50%. Above 70%, operating costs are eating so much revenue that even strong loan growth may not save profitability. This one is particularly useful for comparing banks of different sizes.

Asset Quality Ratios: What’s Happening in the Loan Book

The loan portfolio is usually a bank’s largest and riskiest asset. Asset quality ratios are forward-looking in ways that capital and profitability ratios are not. A bank can report strong earnings today while its loan book is quietly deteriorating. By the time bad loans hit the income statement as charge-offs, the damage is done.

Non-Performing Loan Ratio

The non-performing loan (NPL) ratio divides total non-performing loans by total gross loans. A loan is non-performing when the borrower is 90 or more days past due or is otherwise unlikely to repay.12Bank for International Settlements. Guidelines for Definitions of Non-Performing Exposures and Forbearance During stable economic periods, an NPL ratio below 1% to 2% signals strong underwriting discipline. A rising NPL ratio is one of the clearest early warning signs in banking. It tells you borrowers are starting to struggle, more charge-offs are likely, and provisions will have to rise, which cuts into earnings and eventually erodes capital.

Loan Loss Coverage Ratio

This ratio divides the allowance for loan losses by total non-performing loans. It answers whether management has reserved enough money to cover loans already going bad. Above 100% means the bank has set aside more than enough to cover currently identified problem loans. Below 100%, especially falling, suggests the bank may be understating expected losses, which can produce sudden earnings hits.

Net Charge-Off Ratio

The net charge-off ratio takes loans written off as uncollectible during a period, subtracts recoveries, and divides by average total loans. Where the NPL ratio signals trouble brewing, the charge-off ratio tells you what the bank has already lost. A rate consistently below 0.5% reflects disciplined lending. When charge-offs spike, the horse is already out of the barn. Treat this as a trailing confirmation of earlier NPL trends.

Texas Ratio

Developed during the 1980s Texas savings-and-loan crisis, the Texas Ratio divides non-performing assets (delinquent loans plus foreclosed real estate) by the sum of tangible equity and loan loss reserves. Above 100% means problem assets have exceeded the available cushion to absorb them. Historically, banks crossing that line have faced elevated failure risk. It is not a death sentence, but a Texas Ratio climbing toward 100% is a cue to look much more carefully at everything else.

Concentration Risk

The ratios above describe the current state of the loan book but say nothing about exposure to one sector going sideways. Federal regulators flag banks for heightened scrutiny when construction and land development loans reach 100% of total risk-based capital, or when total commercial real estate (CRE) loans hit 300% of capital and the CRE portfolio has grown by more than 50% over the prior three years.13Office of the Comptroller of the Currency. Interagency Guidance on CRE Concentration Risk Management These are not hard limits. Banks can exceed them with proper risk management. They do mark the point where regulators start paying closer attention, and so should you. A community bank with a 350% CRE concentration heading into a commercial real estate downturn is a different animal than a diversified money-center bank.

Stress Testing: The Forward-Looking Overlay

Ratios drawn from current financial statements are inherently backward-looking. Stress testing pushes a bank’s numbers through a hypothetical economic disaster to see if they still hold up. Under the Dodd-Frank Act, banks with more than $250 billion in total consolidated assets conduct periodic stress tests.14FHFA. Dodd-Frank Act Stress Tests (DFAST) The Federal Reserve designs the scenarios, which typically include a severe recession with sharp unemployment increases, steep declines in asset prices, and disruption in credit markets.

For the largest banks, results feed into the stress capital buffer (SCB), which replaces the standard 2.5% capital conservation buffer with a firm-specific requirement. The SCB has a 2.5% floor but can be higher depending on projected losses under stress. Combined with the 4.5% CET1 minimum and any G-SIB surcharge, it determines total capital a bank needs to maintain before facing automatic restrictions on dividends, buybacks, and bonuses.15Federal Reserve Board. Federal Reserve Board Announces Final Individual Capital Requirements for Large Banks The Federal Reserve has indicated that current stress capital buffer requirements will remain in effect until 2027, when updated models incorporating public feedback will be used.16Federal Reserve Board. Federal Reserve Board Finalizes Hypothetical Scenarios for Its Annual Stress Test A bank that barely clears the minimums under the stress scenario is operating with much less margin for error than one that stays well above them.

Where to Find the Numbers

Every nationally chartered bank and FDIC-insured institution files quarterly Call Reports with federal regulators. These contain the raw data for every ratio above. The FFIEC Central Data Repository makes the filings publicly available, including the Uniform Bank Performance Report (UBPR), which pre-calculates many ratios and lets you compare a bank against its peer group.17FFIEC. Central Data Repository – Call Report For publicly traded bank holding companies, the SEC’s EDGAR database adds 10-K and 10-Q filings with risk factors, management discussion, and capital planning detail. Between the two, you have enough to evaluate any U.S. bank without relying on anyone else’s reading.